Which IP SLA configuration sets up a multicast UDP jitter operation?
Choose an answer
Tap an option to check your answer.
Correct answer: Router(config)#ip sla 1 Router(config)#udp jitter 239.1.1.1 65051 end-point list List source-ip 192.168.1.1.
Why this is the answer
The correct option uses the udp jitter command with a multicast IP address (239.1.1.1) and the end-point list keyword, which is essential for specifying the multicast group for the jitter operation. The source-ip defines the source of the UDP packets. The first incorrect option uses udp-jitter which is not a valid command for this purpose and lacks the multicast group definition. The third option also uses udp-jitter and defines a unicast IP, not a multicast one. The fourth option uses udp jitter but specifies a unicast destination IP (10.0.0.1) instead of a multicast group.
Pass your exam — without the endless answer hunt
Get every verified question and explanation for this exam in one place, and save hours of prep. 1,000+ certifications · 20+ languages · free to start.
Pass your exam faster → No card needed